Fast DeliveryAvailable in the following versions and are designed to be cut to size:
- TC7575PRO – 75cm x 75cm nominal size.
- TC12075PRO – 120cm x 75cm nominal size.
- TC18075PRO – 180cm x 90cm nominal size.
Notes:
- The maximum size frame that can be made from each kit will be 3.6cm longer than stated in each direction.
- The tank should be measured from inside face of glass to inside face of glass.
Included in the kit
The JumpGuard Pro DIY Aquarium Cover Kit is a kit of parts which allows the aquarist to create a custom frame for their specific aquarium. The rigid corners and extruded aluminium section create a very solid frame which sits neatly inside glass of the aquarium glass, resting on the top lip.
Kit Contents:
TC7575
90cm x 90cm 1PC bird mesh, black material
5 x 75cm lengths of section in black extrusion profile
1 x red spline roller tool
6 x black standard corners
Black spline,total length 3.5m
2 x Black finger pull
2 x Reverse corner
1 x 75cm brace bar
4 x brace clips
TC12075
140cm x 90cm 1PC bird mesh, black material
3 x 75cm + 2 x 120cm lengths of section in black extrusion profile
1 x red spline roller tool
6 x black standard corners
Black spline, total length 4.4m
2 x Black finger pull
2 x Reverse corner
2 x 75cm brace bar
6 x brace clips
2 x T corners
TC18090
200cm x 110cm 1PC bird mesh, black material
90cm lengths of section in black extrusion profile
1 x red spline roller tool
6 x black standard corners
Black spline, total length 5.9m
2 x Black finger pull
8 x brace clips
3 x 90cm brace bar
2 x Reverse corner
2 x T corner
Features of the Jumpguard Pro Aquarium Cover
New Profile Design
The special extruded aluminium profile is now shaped with a lip which sits directly onto the edge of the glass, removing the requirement for any additional clips or brackets. The section is extruded then powder coated in a tough, low sheen, black finish for greater scratch resistance and greater aesthetics.
New Profile Design Special Corners integrate with silicone joints
The lower section of the corners is specifically designed so that it does not interfere with the silicone bead in the corners of your tank which gives a tight fit to the glass with no gaps. It also makes it easier and neater to cut off the corner if you want to bring wires out at the back of the tank for pumps and heaters.
New black mesh with maximum light penetration
For those concerned with loss of light penetration into your reef tanks, we tested light levels with a Apogee MQ-200 meter and got the following results:
PAR without cover around 390 – 400 • PAR with cover around 380 – 390 • Approximately a 2.5% reduction in light with no shadowing at all.
Reviews
There are no reviews yet.